{"id":"e367c6c3-e253-4a20-a41e-475e95c11b7a","arxiv_id":"2611.17207","paper_version":1,"verdict":"CONDITIONAL","confidence":"MODERATE","novelty_score":4.0,"correctness_risk":"medium","formal_verification":"none","parameter_count":2,"one_line_summary":"Applying Newman's known phase formula to multi-tone cryogenic detector readout yields a lower crest factor than random phases, but the paper does not prove optimality or handle nonuniform detector frequencies.","lead":"A study of signals used to excite cold superconducting detectors argues that assigning carrier phases with a classical formula called Newman phases lowers the signal's peak-to-average power ratio, leaving more headroom in the electronics. For arrays of ten thousand detectors this can ease the demands on the converter that digitizes the readout.","discovery_kind":"new_application","skeptic_critique":{"model":"deepseek/deepseek-v4-flash","headline":"Newman phase cancellation is demonstrated only for equally spaced tones; real MKID arrays have non-uniform resonance frequencies, so the claimed ~4.6 dB crest factor and sqrt(log N) power gain are unverified for the advertised application.","rationale":"The reader's weakest_assumption pinpointed the equal-spacing requirement, and my independent reading agrees that this is the most load-bearing condition. The paper explicitly acknowledges that MKID arrays are not equally spaced but proceeds to draw quantitative conclusions (power per pixel, ADC noise floor requirements, sqrt(log N) scaling) from simulations that assume equal spacing. This is not a matter of disagreeing with an external consensus; it is an internal gap between the method's proven domain and the application's stated conditions. The core Newman-phase result for the uniform case is real and correctly cited, so the paper is not rejected outright, but the transferability claim must be demonstrated. No other concern is as consequential: the optimality claim is weaker (calls for a proof, but does not undermine the reported numbers), the comparison against the conservative sqrt(N) model in Fig. 5 is a fair choice as a baseline, and the lack of full reproducibility is a practical issue rather than a logical flaw. The concrete test I propose directly removes the ambiguity by simulating the realistic non-uniform case.","tokens_in":11309,"tokens_out":2570,"duration_ms":16754,"concrete_test":"Run a numerical experiment: generate N tones at frequencies f_k that are not equally spaced, e.g., drawn from a realistic MKID resonance distribution (random within the channel bandwidth, or a measured distribution) while keeping the same Newman phases theta_k = pi (k-1)^2/(2N) assigned by channel index. Compute the crest factor of the summed signal u(n) = sqrt(2/N) sum cos(2 pi f_k n + theta_k) over one period T for N = 100, 1000, and 10000. Compare the resulting CF (in dB) to the equal-spacing value of ~4.6 dB. If CF exceeds, say, 8 dB or grows like sqrt(N), the method does not transfer to non-uniform arrays. Repeat with the random amplitudes used in Fig. 4. The test is directly checkable with a short simulation script and would settle whether the paper's central claim holds for its stated application.","verdict_should_be":"CONDITIONAL","load_bearing_attack":"The paper's central quantitative claims—crest factor near 4.6 dB for large N, peak growth like sqrt(log N), and the resulting increase in per-pixel readout power (Fig. 5, Eq. 15)—rest on the behavior of u_new_N(n) in Eqs. (10) and (13), which assumes N tones at consecutive integer frequencies k+N_0 with equal amplitudes. The paper itself acknowledges that MKID resonance frequencies are not equally spaced: it notes that reference [20] states 'the lowest crest factor is obtained by applying carriers equally spaced in frequency, which would not be the case for MKIDs.' Despite this, all simulations (Fig. 4, Eq. 14) and the contour comparison in Fig. 5 are performed under the equal-spacing assumption. The Newman phase formula theta_k = pi (k-1)^2/(2N) is derived for this specific equally spaced, integer-frequency structure; there is no argument or simulation showing that the quadratic phase progression preserves the cancellation property when the carrier frequencies are arbitrary real values within the Nyquist band, as they are for a realistic MKID array. The paper's random-amplitude simulation (Fig. 4) still uses the same equally spaced grid, so it does not probe the non-uniform-frequency case. Without evidence that the crest factor remains low for non-uniform channel spacing, the claimed advantage in readout power per pixel and the sqrt(log N) scaling do not transfer to the actual MKID application. The conclusion that the Newman algorithm is 'optimal' is also unsupported by a proof, but the more consequential gap is the transferability under non-uniform spacing.","agreement_with_reader":"agree"},"referee_report":{"model":"deepseek/deepseek-v4-flash","summary":"The paper reviews readout electronics for MKID arrays and proposes using Newman's quadratic phase formula to reduce the crest factor of the multi-tone excitation signal. It claims that with Newman phases the crest factor stays near 4.6 dB for large N, the peak grows only as sqrt(log N) instead of sqrt(N), and this allows higher readout power per pixel and lower ADC noise requirements. The paper includes simulations of crest factor vs N and contours of required ADC noise density.","tokens_in":11802,"tokens_out":1375,"duration_ms":13286,"significance":"If the claims hold, the method could improve dynamic range utilization in MKID readout, potentially enabling larger arrays. However, the significance is limited because the central assumption of equally spaced tones does not match real MKID arrays, and the paper does not address this gap.","major_comments":[{"comment":"The entire crest factor analysis assumes equally spaced integer frequencies (Eq. 10, 13). The paper acknowledges in §III.A that reference [20] states equally spaced carriers are not the case for MKIDs. Despite this, all simulations and the contour comparison in Fig. 5 are performed under the equal-spacing assumption. No argument or simulation is provided to show that Newman phases preserve low crest factor when the carrier frequencies are non-uniform, as in a realistic MKID array. Therefore, the central quantitative claims (CF ~4.6 dB, sqrt(log N) scaling, and the resulting power-per-pixel advantage) are unverified for the advertised application. This is a load-bearing gap.","section":"III.A.1, Eq. (13), Fig. 4, Fig. 5","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"Equation (14) gives the peak scaling for random amplitudes as 2.6 sqrt(log N) for N>=1000 and 2.4 sqrt(log N) for N<1000. The derivation of these prefactors is not explained; the text says 'simulations were carried out' but no details of the simulation (number of trials, amplitude distribution, phase distribution) are provided. Without this information, the result is not reproducible and its reliability is unclear.","section":"III.A.1, Eq. (14)","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The paper calls the Newman method 'optimal' (b127, b128). However, no proof of optimality is given, and the paper itself cites Boyd [18] who notes that standard optimization techniques do not help much and that Newman phases produce a crest factor only about 1.5 dB lower than Rudin-Shapiro phases. The claim of optimality is unsupported and should be toned down.","section":"IV, Conclusions","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The contours in Fig. 5 are based on Eq. (15) which includes a factor s_max that 'sets the full scale width that the digitized multi-tone signal can achieve.' The relationship between s_max and the crest factor is not explicitly stated, and the calculation of the contours is not described in sufficient detail to be reproduced. The paper states that a 3 dB margin and up to 10 dB variation in Prms are considered, but the methodology for converting crest factor to required ADC noise density is not fully explained.","section":"Fig. 5, Eq. (15)","authors_acknowledge":null,"authors_acknowledge_p":null}],"minor_comments":[{"comment":"The abstract says '~10.000 pixels' but should be '~10,000 pixels' or '~10^4 pixels'.","section":"Abstract","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The phrase 'the main advantage of the working principle of these cryogenic detectors is that it is relatively easy to perform the frequency division multiplexing' is vague. Consider rephrasing for clarity.","section":"I, Introduction","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The notation for the comb signal uses A_k, f_k, phi_k. It would be helpful to state explicitly that the amplitudes are assumed equal in the subsequent analysis, and that the Newman method is defined for equal amplitudes.","section":"II.A, Eq. (1)","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The caption of Fig. 4 says 'the dotted line indicates the value of CF=4.6 dB, the theoretical minimum achievable with the Newman phases.' However, the paper does not derive this theoretical minimum; it is an empirical observation from simulations. The phrase 'theoretical minimum' is misleading.","section":"III.A.1, Fig. 4","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The equation uses a piecewise definition with different prefactors for N>=1000 and N<1000. The justification for the threshold and the specific values is not given. Also, the units of ||u||_∞ are not dimensionless; since u is normalized to unit RMS, the peak is dimensionless, but the equation gives a numeric value without derivation.","section":"III.A.1, Eq. (14)","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The two panels of Fig. 5 have different vertical axis ranges (left: -110 to -60 dBm, right: -90 to -20 dBm). This makes direct visual comparison difficult. Consider using the same scale or explaining the difference.","section":"Fig. 5","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"Reference [13] (McHugh et al.) is cited for the random-phase scaling and the contour method. It would be helpful to briefly summarize the relevant results from [13] to make the paper more self-contained.","section":"References","authors_acknowledge":null,"authors_acknowledge_p":null},{"comment":"The paper contains several grammatical errors and awkward phrasings (e.g., 'the main contribution be seen', 'it is shown an algorithm'). A thorough language edit is recommended.","section":"General","authors_acknowledge":null,"authors_acknowledge_p":null}],"recommendation":"major_revision"},"author_rebuttal":null,"desk_editor":{"model":"deepseek/deepseek-v4-flash","letter":"Hi,\n\nThis paper applies Newman's quadratic phase formula (theta_k = pi (k-1)^2/(2N)) to multi-tone readout signals for MKID arrays and reports crest factors near 4.6 dB for uniform equal-amplitude tones. The review of MKID readout electronics is competent, and the reproduction of known CF values (5.635 dB for N=32, 4.628 dB for N=1024) is correct. The paper also includes a random-amplitude simulation (Eq. 14, Fig. 4) showing that CF degrades to ~10.5 dB when amplitudes vary, which is a useful practical note.\n\nThe soft spot is load-bearing. The entire low-CF construction assumes equally spaced integer-frequency tones (Eqs. 10, 13). The paper itself acknowledges that MKID resonances are not equally spaced (citing [20]), yet all simulations and the contour comparison in Fig. 5 are performed under the equal-spacing assumption. There is no argument or simulation showing that Newman phases preserve cancellation for non-uniform channel spacing. Without that, the claimed ~4.6 dB CF, sqrt(log N) scaling, and power-per-pixel advantages do not transfer to realistic MKID arrays. The paper also calls the method \"optimal\" without a proof of optimality, and the simulations behind Eq. (14) and Fig. 5 are not reproducible from the text.\n\nWho this is for: engineers already familiar with MKID readout who want a clear exposition of Newman phases applied to uniform tones. The review sections are useful for newcomers. But the central application claim is unverified.\n\nRecommendation: I would not desk-reject this, but I would send it back for major revision. The authors need to either (a) demonstrate that the CF remains low for non-uniform channel spacing (simulation with realistic MKID frequencies), or (b) clearly delimit the scope to uniform tones and remove the unsubstantiated claims about MKID arrays. The paper is not a new derivation, but it is a competent application note that could be valuable if the scope is honestly bounded.","headline":"Newman phases are correctly applied to uniform equal-amplitude tones, but the paper's central claim for MKID arrays is unsupported because real resonances are not equally spaced.","tokens_in":12393,"tokens_out":533,"duration_ms":7119},"pith_extraction":null,"created_at":"2026-11-13T09:15:00.792335+00:00","model_set":{"reader":"deepseek/deepseek-v4-flash"},"pipeline_version":"pith-pipeline@v1.4.1-daily-deepseek-or-medium","input_kind":null,"input_chars":null,"input_total_chars":null,"passes_missing":null,"published_standing":null,"published_confidence":null,"objection_audit":null,"run_record":null,"basis":{"kind":"not_recorded","source":null,"chars_given":null,"chars_total":null},"receipt":null,"falsifier":null,"supporting_citations":[],"lane_accuracy":{"status":"not yet measured","lane":{"model":"deepseek/deepseek-v4-flash","input_kind":null},"url":"https://pith.science/accuracy"},"review_version":1}