Influence of star-forming galaxy selection on the galaxy main sequence

This work aims to determine how the galaxy main sequence (MS) changes using seven different commonly used methods to select the star-forming galaxies within VIPERS data over $0.5 \leq z < 1.2$. The form and redshift evolution of the MS will then be compared between selection methods. The star-forming galaxies were selected using widely known methods: a specific star-formation rate (sSFR), Baldwin, Phillips and Terlevich (BPT) diagram, 4000\AA\ spectral break (D4000) cut and four colour-colour cuts: NUVrJ, NUVrK, u-r, and UVJ. The main sequences were then fitted for each of the seven selection methods using a Markov chain Monte Carlo forward modelling routine, fitting both a linear main sequence and a MS with a high-mass turn-over to the star-forming galaxies. This was done in four redshift bins of $0.50 \leq z < 0.62$, $0.62 \leq z < 0.72$, $0.72 \leq z < 0.85$, and $0.85 \leq z < 1.20$. The slopes of all star-forming samples were found to either remain constant or increase with redshift, and the scatters were approximately constant. There is no clear redshift dependency of the presence of a high-mass turn-over for the majority of samples, with the NUVrJ and NUVrK being the only samples with turn-overs only at low redshift. No samples have turn-overs at all redshifts. Star-forming galaxies selected with sSFR and u-r are the only samples to have no high-mass turn-over in all redshift bins. The normalisation of the MS increases with redshift, as expected. The scatter around the MS is lower than the $\approx$0.3~dex typically seen in MS studies for all seven samples. The lack, or presence, of a high-mass turn-over is at least partially a result of the method used to select star-forming galaxies. However, whether a turn-over should be present or not is unclear.