Three-dimensional Simulations of Disk Accretion to an Inclined Dipole: II. Hot Spots and Variability

The physics of the "hot spots" on stellar surfaces and the associated variability of accreting magnetized rotating stars is investigated for the first time using fully three-dimensional magnetohydrodynamic simulations. The magnetic moment of the star is inclined relative to its rotation axis by an angle Theta. A sequence of misalignment angles was investigated, between Theta=0 and 90 degrees.Typically at small Theta the spots are observed to have the shape of a bow which is curved around the magnetic axis, while at largest Theta the spots have a shape of a bar, crossing the magnetic pole. The physical parameters (density, temperature, etc.) increase toward the central regions of the spots. At relatively low density and temperature, the spots occupy approximately 10-20 % of the stellar surface, while at the highest values of these parameters this area may be less than 1 % of the area of the star. The light curves were calculated for different Theta and inclination angles of the disk i. They show a range of variability patterns, including one maximum-per-period curves (at most of angles Theta and i), and two maximum-per-period curves (at large Theta and i). At small Theta, the funnel streams may rotate faster/slower than the star, and this may lead to quasi-periodic variability of the star. The results are of interest for understanding the variability and quasi-variability of Classical T Tauri Stars, millisecond pulsars and cataclysmic variables.