REVIEW 1 minor 17 references
The 2025 test beam dataset supplies new triplet module measurements that advance full qualification of ATLAS ITk pixel modules.
Reviewed by Pith at T0; open to challenge. T0 means a machine referee read the full paper against a public rubric. the ladder, T0–T4 →
T0 review · grok-4.3
2026-06-29 19:31 UTC pith:VTWVDZSF
load-bearing objection This is a routine progress report on 2025 test-beam data for ATLAS ITk pixels; the only clear addition is the first pre- and post-irradiation triplet-module runs.
Recent test beam results of ATLAS ITk Pixel sensors and modules
The pith
A machine-rendered reading of the paper's core claim, the machinery that carries it, and where it could break.
Core claim
The 2025 test beam dataset contains several important new elements, including the first beam tests of triplet modules before and after irradiation, enabling further progress toward the full qualification of ITk pixel modules.
What carries the argument
Test beam measurements of charge-collection efficiency performed at multiple incident angles on irradiated and non-irradiated quad and triplet modules.
Load-bearing premise
Test beam conditions at multiple incident angles accurately represent charge-collection efficiency under actual detector operation.
What would settle it
If charge collection measured in the completed ATLAS detector after installation deviates substantially from the multi-angle beam results, the representativeness of the test beam data for qualification would be called into question.
If this is right
- Triplet modules receive their first beam evaluation both before and after irradiation.
- Multiple-angle data supplies performance information closer to actual operating conditions than single-angle tests.
- The combined quad and triplet results move the program closer to full module qualification.
- An overview of the full ITk pixel test beam program becomes available for planning next steps.
Where Pith is reading between the lines
- The new triplet data could be used to compare pre- and post-irradiation behavior directly in a single module type.
- If the multi-angle approach holds, similar testing protocols might apply to other pixel or strip detector upgrades.
- Differences between pre-production and production chips, once quantified, could guide final production decisions.
Editorial analysis
A structured set of objections, weighed in public.
Referee Report
Summary. The manuscript provides an overview of the ATLAS ITk pixel test beam program with a focus on the 2025 campaigns. It reports evaluations of quad and triplet modules equipped with pre-production and production readout chips, including the first beam tests of triplet modules both before and after irradiation. Measurements were performed at multiple incident angles to study charge-collection efficiency. The central claim is that the 2025 dataset contains several important new elements enabling further progress toward full qualification of ITk pixel modules.
Significance. If the results hold, this contributes empirical test-beam data to the qualification of silicon pixel modules for the ATLAS Inner Tracker upgrade at the HL-LHC. Credit is given for reporting new experimental elements, specifically the first pre- and post-irradiation triplet module tests in beam. The reader's concern that multi-angle measurements may not accurately represent operational charge collection does not land, as this is a standard and accepted method in the field.
minor comments (1)
- Abstract: the description of the test program supplies no quantitative results, error bars, or specific metrics from the triplet module measurements. Adding at least one key result would better support the claim that the dataset contains 'important new elements' and enable readers to assess progress toward qualification.
Simulated Author's Rebuttal
We thank the referee for their positive assessment of the manuscript, accurate summary of the 2025 test beam results, and recommendation for minor revision. We appreciate the recognition given to the new elements, including the first pre- and post-irradiation triplet module tests.
Circularity Check
Experimental report with no derivations or predictions
full rationale
This paper is a descriptive report of 2025 test beam measurements on ITk pixel modules, including pre/post-irradiation triplet tests and multi-angle charge collection data. No equations, fitted parameters, model derivations, or quantitative predictions appear in the abstract or described scope. All claims reduce directly to reported experimental observations rather than any internal chain that could loop back to inputs by construction. The work is therefore self-contained with no circularity.
Axiom & Free-Parameter Ledger
read the original abstract
Test beam studies of ITk pixel sensors and full modules are an essential tool for assessing their performance and operational behavior. In the 2025 test beam campaigns, quad and triplet modules equipped with both pre-production and production readout chips were evaluated. For the first time, triplet modules were tested in beam conditions, both before and after irradiation. Measurements were performed at multiple incident angles to study charge-collection efficiency under conditions representative of actual detector operation. The 2025 test beam dataset contains several important new elements, enabling further progress toward the full qualification of ITk pixel modules. This work presents an overview of the ITk pixel test beam program including recent triplet module results from the 2025 campaigns.
Reference graph
Works this paper leans on
-
[1]
Béjar Alonso et al.,High-Luminosity Large Hadron Collider (HL-LHC): Technical design report, CERN Yellow Reports: Monographs10/2020(2020)
I. Béjar Alonso et al.,High-Luminosity Large Hadron Collider (HL-LHC): Technical design report, CERN Yellow Reports: Monographs10/2020(2020)
2020
-
[2]
L. Gonnella for the ATLAS ITk Collaboration,The ATLAS ITk detector system for the Phase-II LHC upgrade,Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment1045(2023) 167597. [3]ATLAScollaboration,Technical Design Report for the ATLAS Inner Tracker Pixel Detector, Tech. Rep. CERN-LHC...
work page internal anchor Pith review Pith/arXiv arXiv 2023
-
[3]
C. Buttar for the ATLAS ITk Collaboration,ATLAS ITk pixel detector overview,Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment1070(2025) 169978. [6]ATLAScollaboration,Expected tracking and related performance with the updated ATLAS Inner Tracker layout at the High-Luminosity LHC, ...
2025
-
[4]
Piemonte,Device simulations of isolation techniques for silicon microstrip detectors made on p-type substrates,IEEE Transactions on Nuclear Science53(2006) 1694
C. Piemonte,Device simulations of isolation techniques for silicon microstrip detectors made on p-type substrates,IEEE Transactions on Nuclear Science53(2006) 1694
2006
-
[5]
Terzo et al.,Novel 3D Pixel Sensors for the Upgrade of the ATLAS inner tracker,Frontiers in PhysicsVolume 9 - 2021(2021)
S. Terzo et al.,Novel 3D Pixel Sensors for the Upgrade of the ATLAS inner tracker,Frontiers in PhysicsVolume 9 - 2021(2021)
2021
-
[6]
Alimonti, A
G. Alimonti, A. Andreazza, F. Arteche, M. Barbero, P. Barrillon, R. Beccherle et al.,RD53 pixel readout integrated circuits for ATLAS and CMS HL-LHC upgrades,Journal of Instrumentation20 (2025) P03024
2025
-
[7]
Jansen, S
H. Jansen, S. Spannagel, J. Behr, A. Bulgheroni, G. Claus, E. Corrin et al.,Performance of the EUDET-type beam telescopes,EPJ Techniques and Instrumentation3(2016) 7
2016
-
[8]
Banerjee, J
D. Banerjee, J. Bernhard, M. Brugger, N. Charitonidis, N. Doble, L. Gatignon et al.,The north experimental area at the CERN super proton synchrotron, CERN Accelerator Note CERN-ACC-NOTE-2021-0015, CERN (July, 2021), DOI
2021
-
[9]
Hu-Guo, J
C. Hu-Guo, J. Baudot, G. Bertolone, A. Besson, A. Brogna, C. Colledani et al.,First reticule size MAPS with digital output and integrated zero suppression for the EUDET-JRA1 beam telescope, – 9 – Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment623(2010) 480
2010
-
[10]
Cussans,Description of the JRA1 trigger logic unit (TLU), v0.2c, EUDET Memo EUDET-Memo-2009-04, EUDET (2009)
D. Cussans,Description of the JRA1 trigger logic unit (TLU), v0.2c, EUDET Memo EUDET-Memo-2009-04, EUDET (2009)
2009
-
[11]
Y. Liu, M. Amjad, P. Baesso, D. Cussans, J. Dreyling-Eschweiler, R. Ete et al.,EUDAQ2 — a flexible data acquisition software framework for common test beams,Journal of Instrumentation14(2019) P10033
2019
-
[12]
T. Heim, B. Gallop, W. Alkakhi, O. Arnaez, F. Crescioli, L. Foster et al.,YARR, Mar., 2025. 10.5281/zenodo.15007379
-
[13]
Dannheim, K
D. Dannheim, K. Dort, L. Huth, D. Hynds, I. Kremastiotis, J. Kröger et al.,Corryvreckan: a modular 4D track reconstruction and analysis software for test beam data,Journal of Instrumentation16 (2021) P03008
2021
-
[14]
Mandić, V
I. Mandić, V. Cindro, A. Gorišek, B. Hiti, G. Kramberger, M. Mikuž et al.,Measurements with silicon detectors at extreme neutron fluences,Journal of Instrumentation15(2020) P11018
2020
-
[15]
Spannagel, K
S. Spannagel, K. Wolters, D. Hynds, N. Alipour Tehrani, M. Benoit, D. Dannheim et al.,Allpix2: A modular simulation framework for silicon detectors,Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment901(2018) 164
2018
-
[16]
Folkestad, K
Å. Folkestad, K. Akiba, M. van Beuzekom, E. Buchanan, P. Collins, E. Dall’Occo et al.,Development of a silicon bulk radiation damage model for Sentaurus TCAD,Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment874 (2017) 94
2017
-
[17]
Technology computer aided design (TCAD)
Synopsys, Inc., “Technology computer aided design (TCAD).” – 10 –
discussion (0)
Sign in with ORCID, Apple, or X to comment. Anyone can read and Pith papers without signing in.