REVIEW 2 major objections 1 minor 1 cited by
Modeling a circumplanetary disc around YSES 1 b revises its temperature to 2854 K and radius to 1.58 Jupiter radii.
Reviewed by Pith at T0; open to challenge. T0 means a machine referee read the full paper against a public rubric. the ladder, T0–T4 →
T0 review · grok-4.3
2026-07-01 16:36 UTC pith:MSY2J5WQ
load-bearing objection New photometry plus a basic CPD model revises YSES 1 b to hotter, smaller, and higher-mass, but the disc proxy itself is the part that needs checking. the 2 major comments →
The spectral energy distribution of YSES 1 b and its circumplanetary disc
The pith
A machine-rendered reading of the paper's core claim, the machinery that carries it, and where it could break.
Core claim
The central claim is that a circumplanetary disc model, represented by dust extinction plus a blackbody component, provides a significantly better fit to the photometric data than a bare object model. This changes the derived effective temperature from 1727 K to 2854 K and the radius from 3.0 RJ to 1.58 RJ, while increasing the mass to 25.7 MJ or 41.6 MJ depending on whether the system age is taken as 17 Myr or 27 Myr.
What carries the argument
The forward-modeling procedure that combines the companion's atmosphere with a circumplanetary disc represented by a dust extinction law and an additional blackbody radiation term.
Load-bearing premise
The circumplanetary disc can be represented by a simple dust extinction model plus a blackbody component without missing important physical effects or introducing large biases.
What would settle it
An independent radius measurement, for example through high-resolution imaging or spectroscopy that isolates the object's photosphere, that matches 1.58 RJ rather than 3.0 RJ would support the revised parameters.
If this is right
- The mass of YSES 1 b increases into the brown dwarf range for either 17 Myr or 27 Myr system ages.
- Dust extinction from the disc accounts for the previously reported large radius anomaly.
- Similar radius discrepancies in other wide-orbit companions may be resolved by adding circumplanetary disc extinction.
- Accurate masses and temperatures for such objects become more reliable inputs for testing formation pathways.
Where Pith is reading between the lines
- If the simple disc model works here, it may be worth testing on other directly imaged companions that show inflated radii.
- Mid-infrared observations could isolate the blackbody emission from the disc and provide an independent check.
- The revised smaller radius implies the object retains a disc at a later evolutionary stage than expected for its mass.
Editorial analysis
A structured set of objections, weighed in public.
Referee Report
Summary. The paper presents new r', i', z' photometry of the directly imaged companion YSES 1 b obtained with MagAO-X, combines it with archival VLT/SPHERE and NACO data, and performs forward modeling of the SED both with and without a circumplanetary disc (CPD). The CPD is represented by a dust-extinction term plus a single-temperature blackbody; the CPD-inclusive model is reported to yield a significantly better fit, revising Teff upward from 1727 K to 2854 K and radius downward from 3.0 RJ to 1.58 RJ, increasing the inferred mass and moving the object into the brown-dwarf regime.
Significance. If the CPD representation is shown to be unbiased, the result would demonstrate that circumplanetary material can resolve the previously noted radius anomaly for young wide-orbit companions and materially affect mass estimates derived from evolutionary tracks, with direct consequences for formation scenarios and the planetary/brown-dwarf boundary.
major comments (2)
- [Methods] Methods (CPD modeling paragraph): The central claim that the CPD model produces a significantly better fit and drives the large shift in Teff and radius rests on representing the disc by a simple dust-extinction law plus single blackbody; no comparison to radiative-transfer disc spectra, no alternative extinction laws, and no posterior-predictive checks on wavelength-dependent residuals are provided to demonstrate that this proxy does not absorb atmospheric degeneracies.
- [Results] Results (parameter table or text): The revised values (Teff = 2854+110-94 K, R = 1.58+0.06-0.07 RJ) are obtained only after adding the two extra CPD parameters; without reported quantitative model-comparison statistics (Δχ², evidence ratios, or cross-validation) it is impossible to judge whether the improvement exceeds what is expected from the added degrees of freedom.
minor comments (1)
- [Abstract] Abstract: the mass-estimate sentence ('increases from 14+-3 MJ (17 Myr) to either 25.7+4.1-3.6 (17 Myr) or 41.6+3.6-3.4 MJ (27 Myr)') is internally inconsistent in its age assignments and should be clarified.
Simulated Author's Rebuttal
We thank the referee for their constructive and detailed report. We address each major comment below and outline the revisions we will make to strengthen the manuscript.
read point-by-point responses
-
Referee: [Methods] Methods (CPD modeling paragraph): The central claim that the CPD model produces a significantly better fit and drives the large shift in Teff and radius rests on representing the disc by a simple dust-extinction law plus single blackbody; no comparison to radiative-transfer disc spectra, no alternative extinction laws, and no posterior-predictive checks on wavelength-dependent residuals are provided to demonstrate that this proxy does not absorb atmospheric degeneracies.
Authors: Our CPD representation was adopted as a minimal, computationally efficient proxy to isolate the first-order effects of extinction and re-radiation. We agree that full radiative-transfer calculations and alternative extinction curves would provide stronger validation. Because performing such modeling lies outside the scope of the present study, we will revise the Methods and Discussion sections to state this limitation explicitly and to recommend more detailed disc modeling as future work. We will also add residual plots versus wavelength so that readers can directly inspect any systematic trends. revision: partial
-
Referee: [Results] Results (parameter table or text): The revised values (Teff = 2854+110-94 K, R = 1.58+0.06-0.07 RJ) are obtained only after adding the two extra CPD parameters; without reported quantitative model-comparison statistics (Δχ², evidence ratios, or cross-validation) it is impossible to judge whether the improvement exceeds what is expected from the added degrees of freedom.
Authors: The manuscript already lists the χ² values obtained with and without the CPD component. To quantify the improvement relative to the two additional free parameters, we will add in the revised Results section the Δχ², the reduced χ² for each model, and an AIC comparison. These statistics will be presented alongside the parameter table so that the significance of the fit improvement can be evaluated directly. revision: yes
Circularity Check
No significant circularity; forward-model fit to photometry is independent of inputs
full rationale
The derivation consists of acquiring new r'i'z' photometry, combining it with archival data, and performing forward modeling to fit atmospheric parameters both with and without an added CPD component (dust extinction + single blackbody). No equations are presented that define a quantity in terms of itself, no fitted parameters are relabeled as predictions, and no load-bearing premise reduces to a self-citation chain. The central result (shifted Teff and radius) is the direct numerical output of the fit to external photometric measurements; the CPD representation is an explicit modeling choice whose validity can be tested against other data or models outside the present fit. This is the standard, non-circular workflow for SED parameter estimation.
Axiom & Free-Parameter Ledger
free parameters (3)
- effective temperature =
2854 K
- radius =
1.58 RJ
- CPD dust extinction and blackbody parameters
axioms (1)
- domain assumption Evolutionary models accurately convert the derived bolometric luminosity to mass for the assumed system ages (17 Myr or 27 Myr).
read the original abstract
Context. Direct imaging enables the characterisation of substellar companions on wide orbits. These objects provide a testbed for our formation theories; therefore, it is important to obtain accurate physical parameters for them. One of these objects is YSES 1 b. Aims. Our objective is to improve the spectral energy distribution (SED) modelling of YSES 1 b and determine the bulk and atmospheric parameters. Methods. We obtained observations in the r', i', and z' bands using MagAO-X on the 6.5 metre Magellan Clay telescope at Las Campanas Observatory. We combined this data with archival VLT/SPHERE and VLT/NACO data and used a forward modelling approach to estimate the physical parameters. We tested models both without and with a circumplanetary disc (CPD) model. We represented the CPD by including a dust extinction model and a blackbody radiation component. Using the derived bolometric luminosity, we estimated the mass of YSES 1 b by fitting evolutionary models. Results. Including the CPD model provides a significantly better fit to the photometric data, yielding an object that is considerably warmer (2854+110-94 K vs 1727+172-127 K) and smaller (1.58+0.06-0.07 RJ vs 3.0+0.2-0.7 RJ) than previous estimates. The newly determined radius suggests that the addition of dust extinction could resolve the large radius anomaly identified previously. Depending on the age of the system, the estimated mass increases from 14+-3 MJ (17 Myr) to either 25.7+4.1-3.6 (17 Myr) or 41.6+3.6-3.4 MJ (27 Myr). Conclusions. Dust extinction and blackbody radiation from a CPD can substantially change the estimated physical parameters of an object. For YSES 1 b, this moves it into the brown dwarf regime.
Figures
Forward citations
Cited by 1 Pith paper
-
Parameter Effects in Circumplanetary Disk Spectra and Prospects for Spectral Fitting
A parameter-grid radiative-transfer study maps the effects of CPD structure and dust properties on IR spectra and demonstrates spectral fitting to observations.
Reference graph
Works this paper leans on
-
[1]
Allard, F. 2013, Proceedings of the International Astronomical Union, 8, 271 Allard, F., Homeier, D., & Freytag, B. 2011, in ASP Conference Series, V ol. 448 (Astronomical Society of the Pacific) Amara, A. & Quanz, S. P. 2012, MNRAS, 427, 948 Bailer-Jones, C. A. L., Rybizki, J., Fouesneau, M., Demleitner, M., & Andrae, R. 2021, AJ, 161, 147 Bailey, V ., H...
-
[2]
C.1: The posterior distributions for the stellar SED fit using the BT-Settl-CIFIST model
Teff = 4708+30 33 K 3.5 4.0 4.5 5.0 log g log g = 4.46+0.38 0.46 0.98 1.00 1.02 1.04 R (R ) R = 1.02+0.01 0.01 R 10.615 10.630 10.645 10.660 (mas) = 10.63+0.01 0.01 mas 0.025 0.050 0.075 0.100 AV AV = 0.06+0.03 0.04 46404680472047604800 Teff (K) 0.36 0.35 0.34 0.33 log L /L 3.5 4.0 4.5 5.0 log g 0.98 1.00 1.02 1.04 R (R ) 10.61510.63010.64510.660 (mas) 0....
discussion (0)
Sign in with ORCID, Apple, or X to comment. Anyone can read and Pith papers without signing in.